Top Answer
User Avatar
Wiki User
Answered 2009-05-29 11:51:47

The engine will most likely fit, but the engine management computer system will be different- '95 is OBDI and the 98 is OBDII- (On-board diagnostics 1 and 2) the second gen system is much more complex


Your Answer

Related Questions

1998 chevy blazer wont start good spark and good fuel presure

The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.


The transmission dipstick on a 1998 Blazer should be located at the rear of the engine. It should not be near the oil dipstick.

The ERG valve is located on the front of the engine on a 1998 Chevy Blazer V6 4.3L. It is near the top bolted to the intake manifold.

The 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.

I need diagram for 1998 chevy blazer fuse panel

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck

The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.

NO it will not. They are complete DIFFERENT designs. Will NOT interchange.

The oil cap on a 1998 Chevy Blazer is located on the passenger side of the motor. It is just to the left of the manifold cover.

The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.

1998 Chevrolet Blazer did not have vent windows.

The fuel cutoff switch, on your 1998 Chevrolet Blazer, can be found on top of the fuel injector pump. The fuel injector pump is on the back side of the engine near the top.

When owning a car, a person should know the ins and outs of the vehicle. The 1998 Chevy Blazer does have the rack and pinion steering.?æ

The tire jack is located in the rear inside of your Chevy blazer. The jack can be found in a side compartment.

P235/70/R15Chevy Blazer 4WD 2DRwhat is the tallest tire i can put on this 1998 s-10 blazer without causing any problems? thank you

The idle speed is NOT adjustable it is computer controled. Is the check engine light on ? if so then you MUST have the engine scanned with an engine scanner to see what is wrong.

I'm sure it will, But you need to measure both of them first.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.