answersLogoWhite

0

HOW TO GET A PULLEY OFF A 1998 Chevy Blazer

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why won't the heater turn off on a 1998 Chevy Blazer?

Maybe a bad switch


Is there a fuel safety shut off switch on a 1998 Chevy blazer?

If you are referring to an inertia switch for the fuel pump, no.


What would cause 1998 Chevy blazer 2x4 transmission to slip after up to temp?

Blazer does not take off like it should. sluggih slow take off then after it gets going it does wee.


How do you get the fan off of a 1996 Chevy Blazer?

REMOVE THE SINGLE DRIVE BELT, THEN REMOVE THE 4 MOUNTING BOLTS BETWEEN THE FAN AND THE BELT PULLEY. THE FAN MIGHT NEED TO BE WIGGLED OFF


Where is the fuel cut off switch for a 1998 Chevy blazer?

The fuel cutoff switch, on your 1998 Chevrolet Blazer, can be found on top of the fuel injector pump. The fuel injector pump is on the back side of the engine near the top.


Do you have to remove the dash to remove radio in 1998 Chevy blazer?

No. just remove the plastic piece around the radio. It pops off.


How do you manually shut off the kill switch on a 1996 Chevy blazer s10?

There is no "kill switch" on that Chevy Blazer.


Will a fuel pump off a Chevy blazer fit a 96 Chevy s-10?

Need to know what year Blazer.


1995 Chevy s-10 blazer?

where is the fuel shut off swith on a 1995 Chevy s -10 blazer at


Why won't the heater shut off in a 1998 Chevy S10 Blazer?

The heater might not shut off in a 1998 Chevy S10 Blazer because the temperature controls are turned up to heat. The makers of this type of truck and most GMC vehicles allow for constant air to flow throughout the vehicle at all times. In the summer, just turn the temperature control lower.


Why does 1998 Chevy Blazer have an intermittent turn signal clicking noise even when turn signal is turned off?

multi switch on steering coloum is wearing out


How do you install a 1998 Chevy Blazer S-10 right side mirror?

You have to take off the door panel and take the 2 bolts out holding the mirror in place