answersLogoWhite

0

Does a 2000 Chevy Suburban have a cap and rotar?

Updated: 8/18/2019
User Avatar

Wiki User

13y ago

Best Answer

no it does not.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does a 2000 Chevy Suburban have a cap and rotar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the radiator cap on a 2004 Chevrolet Suburban?

wher is the radiator cap on a 2001 chevy suburban


How do you release pressure in the fuel lines on a 2003 Chevy Suburban?

Take off the gas cap.


1987 Chevy s10 Tahoe running rough new plugs distributor cap and rotar any suggestions please help need truck for work pleas?

How about the ignition wires, are they original?


Where is the distributor cap on 2000 Chevy s10?

If your S10 has a 2.2L engine, it doesn't have a distributor cap.


What radiator cap for 350 Chevy?

According to the Haynes repair manual for Chevy/GMC trucks 1988 thru 2000 the cap should be a 15 psi radiator cap.


Does anyone have a diagram of a distributor cap for a 2000 Chevy 2.2L 4 cylinder?

It doesn't have a distributor cap.


Where is the radiator cap on a 2000 Chevy Malibu?

no cap, just the coolant tank, add to this to add coolant../


Can you hear hear fuel pump on 1997 Chevy Suburban?

Yes you can, just take the gas cap off and listen.


What would cause the random misfire on a 1996 Chevy 305 after you change plugs and wires as well as distributer cap and rotar?

The timing is off. it will need to be hooked up to a hand held computer system at a shop to correct this.


Does a 2000-S10 Chevy 4.3V6 have a rotor button?

Yes it does it is under the distributor cap.


How do you properly time a 350 Chevy?

get the first piston on the engine TDC (top dead center) take the cap off the distributer and adjust it until the rotar is pointing at #1 cylinder then it will be enough in time to start then use a timiing light from there


How do you change the rotors on a 2000 Ford F150 2x2?

You have to remove the tire then remove the brake caliper and bracket then you will remove center greese cap and remove the carter pin and remove the will nut lock nut and washer jar the rotar to remove the outer bearing it might be tight due to a greese seal. Once the bearing is removed slide the rotar off.