Yes
Chrysler does not use reset switches.Chrysler does not use reset switches.
because it is
On My 2001 Chrysler T & C it is located on top center in the back of the engine
There are two in the exhaust, behind the engine.
MAP sensor if I recall
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
if it auto transmission ,it in bellhousing ,takes reading off torque converter . i replaced mine when my van not start ,but did no good !! sensor in timing cover was the bad one ! on my 2001 Chrysler voyager
The engine coolant temperature sensor and coolant temperature sensor are the same.
Where is the crank position sensor 0n a 2001 mitsubishi Galant
There are two in the exhaust system on the rear of the engine.
There are two in the exhaust pipe behind the engine.
The throttle position sensor is the three wire sensor on the throttle body opposite of where the cables attach.