0
Yes it does and it is bolted into the passenger lower side of the timing cover.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor on a 2001 Mercedes ML320?
Where is the crankshaft position sensor on a 2001 Mercedes ML320?
Where is the crankshaft position sensor located on a 2001 Chevrolet Blazer with a 4.3L?
It is at the front of the engine, below and to the left of the damper.
Where is the crankshaft position sensor on a 2001 BMW 325 i?
The 2001 BMW 325 crankshaft position sensor can be found on the back of the engine. The position sensor will be near the bottom of the rear engine cover.
Where do you find the crankshaft position sensor on a 2001 Nissan Altima?
Locate the front wire on the distributer and follow. it will lead to the crankshaft position sensor.
2001 Buick Park Avenue where is the crankshaft position sensor?
The crankshaft position sensor is mounted on the front of the engine. It bolts on, and has one wiring plug.
2001 Cadillac Catera crankshaft position sensor location?
into the hood
Where is the Crankshaft position sensor in 2001 dodge neon?
The crankshaft sensor is located directly above the oil filter housing by the alternator.
Where is the camshaft position sensor on a 2001 Chevy blazer?
In the rear of the distributor.
Where is the crankshaft position sensor on a 2001 Chevy Tahoe with a 5.3?
The crankshaft position sensor is located right above the starter, you may have to remove the starter for better visibility.
Where is the crankshaft position sensor on a Hyundai Elantra 2001?
The Crankshaft sensor is located on the front side of the engine block,near the flywheel/driveplate.
Where is the timing belt sensor located on a 2001 kia sportage?
there is no timing belt sensor, only camshaft position sensors and crankshaft position sensor.
How do you replace crankshaft sensor on 2001 s10 blazer?
Locate the crank sensor behind the vibration damper (crankshaft pulley). Unplug the wire harness connected to it. Remove the small bolt holding the sensor in place. Remove the sensor.
