0
Does a 5speed out of a 2.8firebird have a separate bell housing?
Wiki User
∙ 16y ago
I dont think so.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you separate the bell housing from the transmission on a 1996 S10?
The 1996 Chevy S 10 pickup truck bell housing is held in place with eight retaining bolts. Remove the retaining bolts and the bell housing will separate from the transmission.
How do you know if your Mazda 6 is a 4 cylinder or 6-cylinder?
There is nothing you can learn about the clutch by just looking under the hood. The clutch is inside the bell housing--you can't see inside the bell housing by just opening the hood. You would have to separate the transmission from the motor to see inside the bell housing, unless it has an inspection port!
What bell housing do you need to mount Pontiac V6 5speed to a 350 Chevy engine?
before attempting this you should consider the fact that Pontiac v6 transmission will most likely break under load when you put the power of a 350 v8 to it.
Is a 460 bell housing and a 6.9 diesel bell housing the same?
No it is not
Where is the bell housing on a Jeep?
The bell housing is the part of the transmission case that bolts to the engine. The bell housing contains the clutch or torque converter.
How do you remove fourrunner transmission?
You'll have to disconnect the driveshafts, the shift linkage, the speedometer cable, and the clutch (if it's a manual). Then you place a transmission jack centered under it, secure the transmission to the transmission jack, and unbolt the bell housing from the engine block. If you can't access the bolts for the bell housing with the transmission attached, then you'll have to separate the transmission from the bell housing.
To remove engine from an '84 Vanagon do you need to remove tranny also?
No. Not at all. Leave the transmission bolted up front, only undo the motor mount at the bell housing. When you undo the bolts at the bell housing, you can separate the motor from the transmission and roll it out from the back.
Where is crank shaft sensor located on a 1997 Jeep Grand Cherokee?
4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.
Where is the bell housing on an 1994 jeep Cherokee 4.0?
The bell housing is the front part of the transmission where it bolts to the engine. The bell housing surrounds the torque converter and flywheel.
Trying to remove bell housing on a 1981 Chevy Citation thought I have all bolts removed but housing will not separate Is there any bolts that start on the engine side that go to the housing.?
Yes there is one of the bolts that goes in from the engine side
The clutch went out in your 2001 eclipse gt and you can't get the transmission to break free from the bell housing Any suggestions?
why would you want to braek the bell housing free from transmission ? the bell housing needs to be removed to replace clutch, so remove bell housing and transmission as one unit.make sure starter motor is removed. usually blts the secure bell housing and transmission toether can only be reached from inside bell housing after bell housing and transmission are removed from vehicle
Where is the bell housing on 1999 dodge ram truck 5.2L?
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
