No, unless you let the lca rust apart. itll just make annoying noises.
Probably a control arm bushing, possibly a strut mount or stabilizer bar bushing. Mine was the control arm bushing, 2001 Windstar Sport pkg.
Yes.
Check front end for play.
Yes
probably or there part of the same piece ....normally there's multiple bushings on a lower control arm ...i guess it just depends on the vehicle and its probably easier to replace the whole arm rather then individual bushings.
the lower control arms on a 1998 Malibu , are as follows the control arms to frame (front bushing) 45 ftlbs and (rear bushing) is 74 ftlbs....this is strait from gm service
The radius arm is part of the front suspension - connecting from the control arm to the frame. The bushing is at the end that connects to the frame.See "Related Questions" below dealing with the Windstar control arm.
possibly your front upper control arm bushing are out.
First you have to jack the car take off the wheel then remove the brake caliper then remove the sway bar bushing ,then remove the lower ball joint from the shock then remove the bolt that holds the lower control arm in . one towards the front and one towards the back . then remove the control arm . press out the old bushing and press in a new one then revers the procedure.
First you jack up the side of the car you want to replace the control arm bushings and support it with jack stands. Remove the wheel. Remove the stabilizer bar to control arm nut and bolt. Remove the balljoint clamp bolt and nut from the steering knuckle. Remove the bolt and washer front the control arm front pivot. Unbolt the control arm rear bushing retaining strap. Remove the control arm from the car. Once the control arm is off the car you can replace the bushings in it.
AnswerUsually its a design problem, GM & some chryslers have a design similar to a hockey puck mounted horizontally with a vertical bushing in the center. These are very common for breaking. If they used a horizontal bushing design (as in the older RWD cars) the lifespan would be much longer as the stress would moreso be riding on steel bushing not the rubber mount part of the bushing (smaller rubber area needed). Eg: 2000 Chev Cavalier/Pontiac Sunfire front control arm bushings, Rear vertical bushings are very common and I have yet to replace a front horizontal bushing. For an answer that is specific the year, make, and model is needed.
my front arm bushing gone on the front right will it hurt to drive it