Hi must have a small electric motor to turn the disk
stepper motor No. it is not a stepper. It is a Brushless DC (BLDC) motor. See related link for more information on this motor.
Magnetic HARD Disk Drive constitutes of a Disk Platter, Spindle Motor, Read Write Head, Logic Card and Metal Casing with connector.
Well it mostly depends on the motor but its hard on it no matter what it can cause that piston to seize up and blow the motor
could be the motor mounts as to it jerking if its not the tranny..
Hard drives can seldom be used after degaussing because it destroys the drive's timing tracks, servo motors, and usually demagnetizes the permanent magnets of the spindle motor on sealed drives
There's a 12V and a 5V supply. The 5V is for the logic. The 12V supply is for the motor.
check your drive chaft
a hard drive failure is when your hard drive stops working...
a hard drive is called "disque dur" in French.
* Hard disk drive * Hard drive * HDD
If the Hard drive is IDE (40 pins on the back) you would configure the primary hard drive as Master and secondary hard drive as Slave using the jumpers on the back of the hard drive.
It is the same as a laptop hard drive