0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What isolated steel pile?
isolated steel pile
What is the minimum required thickness for pile cap?
Pile cap should no less than 1.5 times the dia of pile
What is micro pile?
A micro pile is a pile with a small diameter (Approx. 100-400mm) and therefore cannot be installed to as great a depth as larger diameter piles.
What does a pile of fagots mean?
Fagots are old English for sticks so it is a pile of sticks
How many methods can enable construction of pile foundations and how?
You can use hammer, press or vibrationdrivers. The most common are hammer and vibrationdrivers, which pound on or vibrate the pile to sink it into the ground. Where noise or vibration would be a no-no, pressdrivers can be employed.Hammer drivers can be operated mechanically, hydraulically or pneumatically. In all types of hammer driver, the ram is raised in a slide and allowed to drop on the head of the pile. Repeat until the pile is at the required depth. Make sure you are wearing your ear protectors if you're nearby. Hammer driving can also have a detrimental effect on nearby buildings, as the seismic waves generated are powerful. Typically the ground around the driver will jump a few inches with each blow.(There is a method in which the ram is constructed to form a single cylinder diesel engine but I'm unfamiliar with this technique. Most of the pile drivers I've seen were hydraulically raised hammer or mechanical vibration types.)Vibration drivers operate on a different principle. Usually there is a hydraulic arm and a motor driving an eccentric cam or a shaft which is weighted to put it out of balance; the vibration causes the earth to assume liquid-like properties and the pile slowly glides in under the pressure of the pile driver arm. This is nowhere near as noisy as hammer driving. Unfortunately the powerful seismic vibration can have a bad effect on nearby buildings and can be quite unpleasant for nearby humans.Press drivers use (usually) hydraulic brute force to push the pile in; doing it like this requires Big Science but has the advantage of being relatively quiet and kind to nearby foundations and people.For driving smaller pilings or for shoring trenches, the bucket of a digger can be used to good effect. Just raise it up and bring it down hard.
What are the release dates for Pile Driver - 1920?
Pile Driver - 1920 was released on: USA: September 1920
What actors and actresses appeared in Pile Driver - 1920?
The cast of Pile Driver - 1920 includes: Billy Franey Charles Haefeli
What does one need to do to be allowed to control pile drivers?
A pile driver needs to have their ITA Certificate of Qualifications or a Certificate of Apprenticeship in Pile Drivers. The role of a pile driver is to construct, remove, installl, or repair deep pile and foundations for such things as bridges, docks and tunnels.
Is a pile driver a compound machine?
yes
Where does a pile driver get the energy to perform work?
torque
What are some unusual sex positions?
The pile driver
How much money does a pile driver make?
A lot
What form of energy does a pile driver use to do work?
elephants
How do you collect souls from caskets in svr 2011?
by pile driver
When you give some one a pile driver does it hurt?
yes alot the wrestlers are actually trained to falll in the right position that we dont exactly noe what it is but if u try it it can break the persons neck noe matter where you try it
Does it hurt more to get hit by a driver or a putter?
If you mean just the club, then the putter would hurt more as it is solid, a driver is hollow. But if you meant which would hurt more if a ball was hit with these clubs and it hit you which would hurt more it would be the driver, the ball speed off a driver can easily reach 120mph.
What is the most dangerous pro wresting move ever?
Probably, the Texas Pile Driver.
