answersLogoWhite

0

no .. Having a seized drive shaft would be like just having the brake on .. will still go in gear .. just wont move ..

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Car shakes while accelerating?

Drive shaft is going out


What can cause a beck noise in your car and your right wheel to shake left to right when you turn?

Seized or damaged half shaft (drive shaft) joint Usually this is a U joint type joint, but not always


How do you remove the drive shaft on a 1999 Ford f150 Ford?

Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.


Is it possible to lengthen a drive shaft on a Yamaha motorcycle?

Yes, it depends on what type of shaft it is to determine how your going to tackle the job.


Will the engine turn over by the crank shaft bolt if it is seized?

No


Who invented the drive shaft and when?

A drive shaft allows torque to enter a motor. Louis Renault of France was the inventor of the drive shaft. He invented the drive shaft in 1898.


Should your front drive shaft turn in 2-wheel drive?

It will turn by hand, But not while going down the road.


Why would a crankshaft pulley seize up in an '89 GMC?

If the cranks shaft pulley is seized, the whole engine is seized.


At what speed does a drive shaft vibrate?

Drive shafts are balanced to prevent vibration, if yours is doing it you need to check your universal joints, and whether the shaft has been dented or if one of the weights used to balance it has fallen off.


What causes a motor to shake going 50 mph?

Possibly a broken motor mount? Depends what kind of vibration you are feeling Have you checked the tires for blisters? What is the angle of difference between the transmission tail shaft and the drive shaft? Has the drive shaft been balanced?


Drive shaft and intermediate shaft the same?

is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no


Is the drive shaft part of the transmission?

The drive shaft is part of the drive train, not part of the transmission.