It has to be on a slight downward slope from your house so the condensation can drain otherwise it will leak into your dwelling. as far as the angle I do not know.
No Angle Whatsoever, Level is the required setting.
LEVEL! All other courses of brick will be based off the first. Thus, without this being level your corners will not be square. If you need to make up for height differences, you should "step" the brick. They should be level because at some point, your brick rows will come in contact with something that IS level (like a window) and it will look extremely odd to not have a constant joint underneath the window.
6.4
The Yamaha Virago 535 has a circular window on the front left side of the crankcase, immediately behind the shift linkage. The bike needs to be held upright (second person) and then the use of a flashlight helps see the level in the window. Level should be approximately center of the window.
Open Another Window of This Is The Only Level 3. (it may have to be on the same website) Then you should see on the other window just a switch. click on it, and look on the window you r gonna play on. the gate will now open
There is a window near the bottom of the engine beneath the fill plug. Hold the bike straight up, and look at the window. The oil should be half way up in the window.
the regulator is riveted in, so you have to move the window position to where you can see the bottom two bolts in the access hole in the door. i think it is pretty close to about mid-way; half of the window is down, half of the window is up. unbolt the two bolts at the bottom, hold the glass and tip the large end upwards towards the top jamb. (that makes it easier to get out.) repeat in reverse to get the window in. the regulator should still be in the same spot. angle the window downwards, line the ends up with the sash, and level the window out. make sure that the window is in the sash correctly by sliding it up and down by hand. move the window into position and bolt it back to the regulator. the regulator is riveted in, so you have to move the window position to where you can see the bottom two bolts in the access hole in the door. i think it is pretty close to about mid-way; half of the window is down, half of the window is up. unbolt the two bolts at the bottom, hold the glass and tip the large end upwards towards the top jamb. (that makes it easier to get out.) repeat in reverse to get the window in. the regulator should still be in the same spot. angle the window downwards, line the ends up with the sash, and level the window out. make sure that the window is in the sash correctly by sliding it up and down by hand. move the window into position and bolt it back to the regulator.
Depends on the ambient air temperature, humidity level, and type of refrigerant used.
Answer your self dont know
Lintel level is the top of window and doors level of a building.
Turn the conditioner when you are using the heater. It will decrease the humidity level (which causes windows to fog up.)
C2 level security.