OBX
on the intake manifold
on top of the aluminum intake manifold, back near the firewall.
To remove the intake manifold on a 2001 Eclipse GT, start by disconnecting the negative battery terminal to prevent electrical shorts. Next, remove any components obstructing the manifold, such as the air intake duct, throttle body, and vacuum hoses. Then, unbolt the intake manifold from the engine, making sure to label or take note of where each bolt goes. Finally, gently lift the manifold off the engine, being cautious of any remaining gaskets or seals that may need replacement.
Basically you remove the throttle body, fuel rail, and anything else that is plugging into it, then unbolt it. You need to get a shop manual however, because there is a specific bolt pattern you need to use to avoid damage.
Under the intake manifold. where is the intake manifold!
jaguar 2001 Lower Engine Intake Manifold Gasket
On a 2001 Dodge truck, the turbo boost sensor, also known as the manifold absolute pressure (MAP) sensor, is typically located on or near the intake manifold. It can be found on the driver's side of the engine, mounted to the intake manifold or in the vacuum line leading to it. For precise location, it’s often best to refer to the vehicle’s service manual or consult a repair guide.
what is the cost to replace a 2001 v-8 manifold intake
i think u r talking about the MAF sensor or mass air flow sensor which is like half way between the air filter and the intake manifold on the air tube
Under the INTAKE MANIFOLD
around 6-7 hours according to AllData
remove the intake manifold then they're in the back. I'm sure u see the front 3. peace