91 probably has an electronic speedo 2 wire sensor in trans near pass side axle 91 probably has an electronic speedo 2 wire sensor in trans near pass side axle
It could be anything from transmission speed sensor to just a broken speed cable.
how do you open the hood on a 1992 buick regal if the cable is broke
Shift Cable
Remove the grill
To change the antenna cable on a 1998 Buick LeSabre Limited, a person has to unscrew the old antenna cable from the back of the radio. Then pull the antenna wire out from under the dash and follow it to the antenna. Unscrew the old cable from the antenna. Screw in the new cable and thread it back under the dash in the same path as the old cable and screw it to the back of the radio.
Well, replacing the speedometer cable on a 2004 Buick Century is a wonderful opportunity to show your car some love and care. Start by locating the cable on the transmission and follow it to the back of the speedometer. Gently disconnect the old cable and replace it with a new one, making sure to secure it properly. Remember, there are no mistakes, just happy little accidents in the world of car maintenance.
im not so sure
To detach the cable from the spare tire on a Buick Rendezvous, first locate the spare tire beneath the vehicle. Use a wrench or a socket to loosen the nut that secures the tire to the cable. Once the nut is loosened, pull the cable upwards to release the tire. Ensure you store the components safely after detaching the tire.
On top of the transmission where the shift cable is.
flnd the positive battery cable fallow it down to the starter
If the heat selector will not switch from defrost to the dash or foot vents on a 1992 Buick, it is possible that the cable connected to the vent is broken. When the selector is moved from defrost, a cable opens the other selected vents on the heater.
To change the gear shift cable on a 2003 Buick Rendezvous, first, ensure the vehicle is securely lifted and supported. Disconnect the battery, then remove the center console to access the cable attachment points. Detach the old cable from both the transmission and the gear shift lever, and then install the new cable by reversing the process. Finally, reconnect the battery and test the gear shifting functionality.