0
What else can I help you with?
Unstable idle engine running check engine lamp is blinking explosions in inlet manifold What is the problem Daewoo Nexia 1.5 16V?
Check the lambda sensor, and clean the idle control valve. Iac is placed in the back side of trothle.
How do you check what the fault is on a daewoo matiz malfuction indicator lamp comes on?
Go to someone who has a diagnostic meter , they will be able to tell you what is causing the problem, it is usually a sensor.
Why is the malfunction indicator lamp on Honda Pilot lit up?
This light could be on due to a defective fuel cap.
How do you remove the side indicator lamps on a Volvo S60?
Begin by removing the side indicator lamp connector. Take hold of the lamp, push in and turn at the same time. The lamp will come out.
How do you reset Toyota hilux 166R t belt indicator lamp?
The easiest way to reset the timing belt indicator lamp in your Toyota automobile is to remove the fuse for the indicator lamp. Keep the fuse out for approximately 30 seconds. Put the fuse back in and the indicator light should be off.
The indicator lamp in a dry iron comes on when the is plugged in but the iron does not heat up this is an indicator that the?
If the indicator lamp in a dry iron comes on when the iron is plugged into the power socket, but the iron does not heat up, it indicates that your iron has a problem with one of its electrical components.
What is a alchohol lamp and what is the use?
This is a lamp using alcohol as fuel.
How can you reset malfunction indicator lamp?
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
How do you change indicator lamp on a vr commodore?
which one? front, rear, side?
What is diagnostic code P0650?
Malfunction indicator lamp control circuit malfunction
What is indicator lamp and how does it work?
Read about it : http://en.wikipedia.org/wiki/Lamp_(electrical_component)
Name at least one indicator that a head lamp was on at the time of a vehicle collision?
If the the lamp is busted from impact, the filament would be burned out if the lamp was on at the time of impact. The position of the switch.
