0
If it is not a sealed bearing then this is normal, in fact bearings must periodically be repacked. However if it is a newer vehicle with sealed bearing then this could mean a possible seal that has pushed out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you put grease in the wheel bearings of a 1989 Topaz?
You must remove the wheel bearings, inspect them, repack them with grease, and install them back in the vehicle.
How does a person grease the bearings of a 1984 mallard travel trailer?
The bearings of a 1984 Mallard travel trailer can be greased by jacking up the trailer and removing the wheel hubs to access the wheel bearings. Pack the bearings with the proper grease and replace the wheel hubs and tires.
How do you check oil in wheel bearing?
There is no oil. Wheel bearings contain grease.
1997 QX4 breaking problems?
make sure when you replace the pads, you repack the wheel bearings, replace the grease seals, set proper tension on the bearings, and resurface or replace the rotors
How do you grease rear wheel bearings on a 1982 Chevy 1 ton van?
The bearings run in the differential grease fed through the axle housing.
Can you grease wheel bearings on 1999 Ford Taurus?
The wheel bearings in the 1996 and newer Taurus / Sables cannot be greased.See "Related Questions" below for information / procedures for replacing wheel bearings.
What should wheel bearings be checked for?
leaking grease or cracks Looseness
How do you grease front wheel on 1990 Plymouth sundance?
The front wheel bearings are sealed and are not greaseable.
How do you grease rear wheel bearings on a 1991 grand am?
You don't. In the 1991 Pontiac Grand Am, the wheel/hub assembly is pre-built at the factory and as such, can not be disassembled for maintenance. If you are having trouble with lubrication or worn bearings, you must replace the entire assembly.
Do you grease dually rear axle bearings on 1 ton Chevy?
Chevy has a floating axle, the bearings share grease in common with the differential. By filling the diff you are greasing the wheel bearings. Onjig
Do your wheel bearings need replaced?
Yes! These pin bearings are surrounded by high temp grease, the grease is kept where it should be by rubber seals. Once these seals are worn out, and cracked, or broken completely, the grease finds its way away from the bearings, and then you have metal on metal contact. There are four parts to a bearing system on each wheel; the inner bearing, outter bearing, and racers for both. the bearings run along the racers, and without the proper amount, and quality grease, these pin bearings with soon break the racer/lose bearing from retainer/lock up/or just simply over heat and STOP the wheel from turning. so, replace those bearings, and get NEW high temp bearing grease and chock it FULL. this will prevent any future problems.
Do 1995 Crown Victoria have grease fittings that will allow one to grease the wheel or are they sealed?
There are no grease fittings on the wheel of any car. The wheel bearings must be removed, cleaned, inspected, repacked, and replaced.
