what is the diference betwean calculated and maesured value
V = I*R, so take 100 volts and divide it by the value of the resistance to get the current. Current is measured in amperes.
Wheatstone bridge is used to calculate the resistance of unknown resistor in the circuit.
A conventional voltmeter displays 0.707 of the peak voltage when it measures AC.In doing so, it displays the RMS value of the measured voltage IF the measured voltage is a sinusoid.If the measured voltage is not a sinusoid, then its peak value is 1.414 times the displayed number, andyou have to calculate the RMS based on the waveform.
Simply put, the purpose of a resistor is to 'resist' the flow of current. Ohm's Law tells us that for a given voltage, the larger the resistance, or value of that resistor, the lower the current that will flow. Ohm's Law states that I (current) = E (voltage) / R (resistance) - where current is measured in amps, voltage is measured in volts and resistance is measured in ohms.
what is the resistance value of a healthy earth pit
No, a resistor isn't measured at all. A resistor has a quality called "resistance" - and that value is measured. Resistance is measured in Ohms.
yes , there is a difference because there is a tolerance
V = I*R, so take 100 volts and divide it by the value of the resistance to get the current. Current is measured in amperes.
Percent error refers to the percentage difference between a measured value and an accepted value. To calculate the percentage error for density of pennies, the formula is given as: percent error = [(measured value - accepted value) / accepted value] x 100.
Current can be measured with an ammeter. If you want to calculate it from other values, you will quite often use Ohm's Law (just divide voltage by resistance, if you know the resistance value of the resistor) - or perhaps a combination of Ohm's Law and Kirchoff's Laws.
Wheatstone bridge is used to calculate the resistance of unknown resistor in the circuit.
if not disconnected you will measure the resistance of the circuit in parallel with the resistor.
A simple subtraction. Take the smaller from the larger
Tolerance indicates how much the measured value of a resistance is different from its theoretical value, and it is calculated using percentages.
A measured value is one that is directly obtained from the environment, such as using a scale to weight something. To calculate a value is to figure it out using other values. For example, if you know the distance something traveled and the time it took, you can calculate its speed.
about 27ohms
you have to have the origial key .measure resistance across pellet in key ,get resistor of same value ,install across connection below steering colum ,wala