Possible, but a bit unlikely. However, a blocked or obscured mass air flow sensor combined with the thinner air might do it.
The oil pressure sensing unit is right above the oil filter on the front of the 4.7L 2001 Grand Cherokee.
the nerve endings that detect pressure on your skin are called what
gas and a pressure
It is the sensing mechanism for oil pressure levels in a car
on a 2005 Honda Accord where is the low pressure AC switch
The fuel tank pressure sensor is actually the fuel pressure regulator. There is a sensing unit within the regulator.
Yes. You would expect the pressure to drop. A low pressure system consists of rising warm air that swirl around a center. Because the air is rising, it lowers the air pressure pressed on the ground. Because of this the pressure-sensing barometer will read that the air pressure is lower. Lower pressure means rain because the warm rising air makes clouds. Expect the pressure to drop as a storm is a low pressure system. Note that cyclones/hurricanes have even lower pressure.
The OEM tire pressures are regulated by the vehicle characteristics, not the tire. The same tire may be used on many different vehicles at many different operating pressures. The normal safe operating tire pressures of a vehicle are determined by the vehicle manufacturer and not the tire manufacturer. The only tire pressures that are listed on the tire are the MAXIMUM operating pressure for ANY application and the maxumum BEAD SEATING pressure. The Tire pressure sensors are calibrated to the OEM pressures, probably would not be programable. All the pressure sensing system does is warn of low vehicle tire pressure (probably below the vehicle posted minimum), correct? If the system reads and displays the actual pressure in the tire, then pressure is pressure and will remain the same regardless of the tire brand or size.
Anenometers usually measure wind speed, but can also measure wind pressure as well.
remote sensing
no because king cobras have hoods and no heat-sensing pits,while the pit viper has no hood and has those heat-sensing pits.
Lspv-load sensing proportioning valve is the part of break assembly .it senses the load of vehicle and aply an effective pressure with respective to the vehicle loaded or unloaded & break the vehicle.also avoid skiding of vehicle.