The viscosity of a substance will change with both temperature and pressure. For liquids the changes induced by a change in temperature are usually more readily observed than the changes from pressure because liquids are only slightly compressible with pressure. In gasses, the changes in viscosity with pressure are much more easily demonstrated because gases are, almost by definition, quite compressible so that the density can be easily changed by either changes in pressure or changes in temperature.
The density of a compressible fluid changes with pressure, while the density of an incompressible fluid is not affected by pressure (assuming isothermal conditions).
keep temperature in control
In a reheat turbine the stean first enters high speed turbine so its temp and pressure reduces before entering low speed turbine so a reheater is used to reheat the cooled steam
The zero shear viscosity is the value of the apparent viscosity (quotient between shear stress and shear rate) of a liquid in the limit of zero shear rate (i.e., when the fluid it is at rest). Therefore it is not the result of a direct measure but a calculus or interpolation from experimental results at the lower shear rates values. The most important thing is its physical meaning. It represents the ability of the material to avoid sedimentation when storage. A high zero shear viscosity is interpreted as a the material will show homogeneous during long storage.
the straight easy answer is no. Although,I guess id one really wanted to,you could change the compressor oil,Expansion valve,& basically re-engineer the system you could. But as far as removing the R-22,& recharcing with R134A,definately no.the temperature to pressure relationship is way different in the 2 refrigerants(with 134A running at a lower temp & pressure vs. r-22)
yes
It changes based on vehicle, outside temp, and desired inside temp. Pressuse depends on ambient temperature, the higher the temp, the greater the pressure
Variation of pressure and temperature..that changes. Gas into liquid..temp should be decreased likewise pressure..
roughly three centepoise
As temperature increases viscosity decreases.
causes are change the color and viscosity saliva
it affects the viscosity because the liquid changes the shape and turns it to a gas and the viscosity by change the form
This is normal as when the engine warms the viscosity of oil lessens, thus also reducing the oil pressure. On a cold start the oil pressure is on the high side, say reads at 75 at idle, then at operating temperature it can just read between 25 to 50 at idle speed, depending on which viscosity rating of the oil you use.
The coefficient of viscosity of liquids decreases with an increases in temperature.
The oil reaches a temp too high to maintain viscosity capabilities. Usually higher than the operating temperature of a vehcile.
The viscosity of blood (cells + plasma) at 36.6 degrees Celsius (normal body temp) is 0.0027 [N-s/m^2].
Pressure and temperature are the two factors that affect flow and viscosity. Viscosity refers to the resistance of a liquid to the shear forces.