Yes. Anytime you work with the alternator you should disconnect the negative battery cable. You don't want to accidently touch a positive connection on the aternator while loosening the alternator holding nuts/bolts.
Disconnect the battery. Loosen the alternator bolts and slide the alternator to loosen the belt. Remove any other belts in front of the bad belt if necessary to get to it. Remove the alternator belt, and install the new one. Pull the alternator to the side to tighten the new belt snug and hold while tightening the bolts. Reconnect the battery
1. Disconnect battery cables. 2. Remove and replace alternator. 3. Reconnect battery cables. The alternator should be held in place by a couple of bolts. what about the belt tension
The belt turning the alternator which is recharging the battery.
disconnect the battery. Remove the alternator belt then disconnect the wires. Unbolt the alternator and remove. Bolt the new alternator in then connect the wires, belt, and battery.
the belt is worn and loose change the belt and tension properly
Disconnect the battery, then remove the alternator belt on the Regal. Unhook the alternator wiring and bolts, then remove it. Installation of the new unit is reverse of the procedures.
Very easy. Disconnect the battery. Lift up the belt tensioner and slip the serpentine belt up off the alternator pulley. Remove the 3 bolts holding down the alternator. Unplug the voltage regulator cable from the alternator. Disconnect the positive battery cable from the alternator. Installation is the reverse of removal.
Corroded or loose battery connections, loose alternator drive belt, defective alternator, or dead cell in the battery.
Disconnect the battery negative terminal. Remove serpentine belt. Remove bolts to alternator and positive cable at alternator and harness. Remove alternator. Reverse procedure to install.
how do you change 2004 kia sorento alternator belt
Battery light usually means alternator not charging. Most common solutions would be be a bad alternator, bad connection, or loose alternator belt. If the battery and alt test ok than check the connections to the alternator and battery.
Loosen the alternator tensioner bolt. The alternator belt will become loose. Remove the alternator belt. Put the new alternator belt on and reverse the process.