answersLogoWhite

0

No.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What does the current equals in a bridge rectifier?

In a bridge rectifier, the current output is the same as the input AC current during the positive half-cycle of the AC waveform. However, during the negative half-cycle, the diodes in the bridge configuration allow current to flow in the same direction, effectively converting AC to DC. The output current can be influenced by the load connected to the rectifier and may vary based on the input voltage and the characteristics of the rectifier circuit.


Which type of rectifier has the greatest output voltage for the same input voltage and trasformer turns ratio?

Bridge Rectifier


What is output frequency of bridge rectifier?

twice the input frequency


What are the advantages and dis advantage of full-wave bridge rectifier compared with two diodes rectifier?

in full wave bridge rectifier, the input and out put voltages are same but in case of two diode rectifier the input and output voltages can be different as per requirement a there is a transformer in the circuit. The former is lighter and the later is heavier.


How do you derive PIV of Bridge rectifier?

A: The input peak value is the guide for PIV


What is the use of bridge rectifier?

Most of the circuits comprising of electronic components run on dc supply.. As DC supply is not available directly for us, we use either 230/12V or 230/18V transformer to stepdown the available 230V (in some countries it is 110v) and then convert it into dc using a rectifier. As a bridge rectifier is more efficient than a conventional full wave rectifier, about 81.2%, it is widely used in such type of circuits.


What is the input output of rectifier?

Current flowing in only one direction.


Why the bridge rectifier is best?

What is the advantage of using the bridge rectifier A: NONE no advantage the only advantage can be considered it the fact it will provide more voltage but never more power actually less by a .7 volt diode drop


What happens when you lose an input phase on a three phase bridge rectifier?

If the rectifier is wye connected, ripple will increase. If it is delta connected, ripple will substantially increase. Whether or not the rest of the rectifier, filter, and regulator are damaged will depend on how much current is being pulled by whats left, and by how deep the ripple actually becomes.


What peak reverse voltage is needed on a bridge rectifier at 120 ac input?

120 * square root of 2


Full wave rectifier using RC triggering circuit with diagram?

A full-wave rectifier (sometimes called a "bridge" rectifier) produces output current on both half-cycles of the input AC waveform. ******************************************** There are two types of full wave rectifier circuit. One uses four diodes in a "bridge"configuration and is fed from a simple transformer winding. The other uses two diodes and needs to be fed from a centre tapped transformer winding.


What are advantages of bridge rectifier?

A bridge rectifier will rectify both halves of a sine wave and give "continuous output" through 360 degrees of the input. Oh, and you don't need a center-tapped transformer to use it.