0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Who was hurt by the light bulb?
Those who are not careful.
Why do you need lamp shades for your lamps?
To diffuse the light otherwise a bright and straight light beam from the bulb will hurt your eyes.
If you were shot from 10 meters away by a c02 air pistol with a pellet that travels at 380fps with a full c02 bulb in it would it stick in you if not really hurt?
Yes it would hurt and depending on your clothing it may or may not penetrate your skin.
Is it safe to use a microwave without a light bulb cover?
There is a small chance that if you splatter something it will get in the light bulb terminal and make it rust or cause the light to shut off or burn out. It isn't going to hurt the microwave if you don't have the cover on though.
How did Benjamen Franklin discover electricity?
He Flew a kite with a piece of metal on the kite flew it on a windy night and he was holding a weird contraption (Light Bulb) in his hand and when the electricity hit the light bulb it turned on Benjamin Franklin was really hurt and had to go to the hospital immediately.That is how Benjamin Franklin discovered Eletricity
What is a fuse bulb?
a fuse bulb is a bulb in which the filament of the bulb burns and it stops working
What is a electric bulb in short?
a bulb is light bulb
How do I install a 1999 Mazda 626 license plate bulb?
Just did this on my 1998 Mazda 626 ES it goes as follows:-From the outside of the trunk look above the license plate.-Use a screw driver to pry out the light fixture by sliding it left or right then tilting it out of the hole.-From the top of the light fixture twist the bulb assembly out of the fixture.-If the auto shop sold you the whole bulb assembly then just twist the new one back in and you are good.-If the auto shop sold you just the bulb, you need to unhook the bulb wires off of the bulb assembly and even scrape them off of inside the metal plate they are hooked around to get the bulb out.-Unbend the wires on your new bulb so that they stick out below the bulb.-Insert the bulb straightened wires first into the assembly.-From the back of the assembly where the wires now stick out, bend the wires over the metal plate in the same fashion that the old ones were.-If you have some solder it won't hurt to tack this wire down. I didn't and my lights work (so far).
Is beans a bulb?
no it is not a bulb
What is a sentence with the word bulb?
Bulb is a noun. Example sentences: I want to find an LED bulb to replace the incandescent bulb that burned out. The thermometer was made of glass, with a bulb at the end.
Why does a light bulb light in a closed circuit?
A bulb does not light up if there is no voltage available across the bulb, or if the bulb is burned out.
How do you make a bulb which glow on your clapping bulb?
you have to need IC 3 ,bulb
