Brazzers is the one who did it
A) the distance traveled by water in a channel times a drop in elevation b) the drop in elevation of a stream divided by the distance the water travels c) the water pressure at the bottom of the stream divided by the stream's width d) the increase in discharge of a stream per unit drop in elevation
A bolt of lightning is about the width of a human thumb, which is roughly 1 inch. The factors that determine the width of a bolt of lightning include the amount of electrical charge, the distance it travels, and the atmospheric conditions.
A lightning bolt can be as wide as 1 inch to several inches. The width of a lightning bolt is determined by factors such as the amount of electrical charge, the distance it travels, and the atmospheric conditions.
The gate voltage controls the extent of depletion layer and thereby controls the width of the channel. As the width of the channel varies, current also varies. Width of the channel is inversly proportional to drain current.
A lightning bolt is about the width of a human thumb, typically around 1 inch (2.5 centimeters) thick. The factors that determine the width of a lightning bolt include the amount of electrical charge, the distance it travels, and the conductivity of the air it passes through.
no
A bolt of lightning can be about 1 inch wide, but can vary depending on factors like the strength of the electrical charge, the distance it travels, and the atmospheric conditions.
Closest (non-UK) country to London is France, just across the English Channel about 93 miles (149 km) away. (At Dover, the Channel is only 21 miles, or 34 km, in width).
The English Channel is 350 miles long.
if channel width decreases , the drain current(Id) will also decrease . but , Id will decrease up to a certain limit , when the jfet is in pinch off condition i.e. channel width is tends to zero (Vgs is very high) the Id will be constant then.
It is the length and width of your HAND
yes . the distance should be one and half times the size of goal width. hence for a 24' goal width ,distance should be 36'.(8 yds and 12yds).... for a 10' goal ,the distance should be 15'.