Yes it does and I would like too know why?
The difference between a front load washer and regular washer is that a front load washer has a door in front were clothes are loaded and that is also where washer settings are located. The regular washer is usually a top load where clothes are loaded on top of the washer.
maytag washer model mtw5800two
Nope itll ruin the washer!! And itll start to smoke....happened to me and i had to buy a brand new washer :(
That will depend on the make of the washer. Warm is usually 30-40 degrees Celsius.
How is the conflict resolved?
The 2001 Villager washer fluid level sensor is inside of the washer fluid reservoir. The sensor can be access through the bottom of the washer fluid reservoir.
The sensor is inside the water bottle
All you need to do is add washer fluid. If the light is still on, the sensor or wiring have failed.All you need to do is add washer fluid. If the light is still on, the sensor or wiring have failed.
color loss, washer, always was on cold for color fastness. shrinkage is dryer, you can avoid this by using low heat or no heat tumble dry
NO!
Fill washer resevoir - if it does not shut off possiby a bad sensor
Fill the washer fluid or repair the level sensor in the washer fluid bottle.
There is a magnetic float inside the washer fluid tank that causes a magnetic sensor on the outside of the tank to activate when the fluid is low. Either the sensor is bad or the float is stuck.
out of balance
If you mean the low coolant sensor, it is located on the radiator about 3-4 inches below the cap, it screws into the back side of the radiator. There is also a low washer fluid sensor located in the top of the winshield washer reservior.
The washer fluid sensor is probably bad.
about two fiddy