0
What else can I help you with?
There is a chime when you turn on your headlight that won't stop how can you stop the chime?
on the left side of the steering column is a knob that controls the lights. Pull it of push it until the beeping stops
How do you turn off seatbelt chime in 2010 ram 1500?
To turn off the seatbelt chime in a 2010 Ram 1500, you can follow these steps: Start the vehicle and buckle the driver's seatbelt. Then, unbuckle it and repeat this process three times. After the third time, the chime should stop. If successful, the chime will remain off until the battery is disconnected or the system is reset.
Can you turn automatic headlights off on a 1998 Chevrolet blazer?
yes, I have a 2000 Chevrolet blazer and to turn the daylights (Automatic lights)of on it you have to push the "DOME OVERIDE" button until the chime sounds or until the lights go out ussually about 3 times...anymore questions just ask me at yamaha_100rt@yahoo.comJared Mullins AKA Blazer BoyAnsweryes, I have a 2000 Chevrolet blazer and to turn the daylights (Automatic lights)of on it you have to push the "DOME OVERIDE" button until the chime sounds or until the lights go out ussually about 3 times... anymore questions just ask me at yamaha_100rt@yahoo.comJared Mullins AKA Blazer Boy
How do you disable seat belt chime on 2011 Hyundai sonata?
To disable the seat belt chime on a 2011 Hyundai Sonata, first, ensure the vehicle is in the "On" position without starting the engine. Fasten and unfasten the driver's seat belt three times, ending with the belt unfastened. After the third unfastening, the chime should stop; you may hear a confirmation chime. If done correctly, the seat belt reminder chime will remain disabled until the battery is disconnected or the procedure is repeated.
Check battery status for your laptop?
To check the status of your laptop, you look at the bottom of your laptop for the battery. Look for the button near a row of LED lights. Once you've found it, press it to see how much charge it has, but to check the health status of your battery press it and leave it pressed until the LED lights blink. The less the lights that turn on the better.
Which battery cable resets service lights in saturns?
While some vehicles require you to momentarily remove the battery cable to reset the service engine light, Saturn uses a much more civilized method. Look in the fuse compartment, the one near the battery. There should be a push-button marked "oil" or something similar.With the key turned on but the engine NOT started, push and hold the button for 5 to 10 seconds or until you hear the chime. THEN the service engine light has cleared.
What is the weight of a Dodge Intrepid?
The curb weight of the Dodge Intrepid in 3,318 pounds of 1,505 kilograms. It was produced for model years 1993 until 1997.
How do you disable seat belt chime on 2011 gmc sierra?
Beside the dash cluster on the left there's an information button. Push it until you see chime volume on your dash, where your mileage is. You can turn the volume to the chime up and down or off.
How do you calibrate the Daniel Dakota Westminster Chime?
To calibrate the Daniel Dakota Westminster Chime clock, first wind the clock fully. Then adjust the time to 5 minutes before the desired time and let the clock chime. You can fine-tune the clock by adjusting the minute hand to the exact time when the chime sequence ends. Repeat as needed until the chime matches the correct time.
What is part number pa66-gf33 for a 1991 Dodge Intrepid?
PA66-GF33 is a purge solenoid for the evaporative emissions control. There wasn't an Intrepid until 1993
Why do my hazard lights keep blinking on 1988 Mazda B2200 truck until I turn headlights on but then the turn signals stop working?
first make sure hazard lights are not on.next you need to ckeck the grounds from the battery.
Why does the 97 grand Cherokee's interior lights come on when key is removed and stay on until the battery is drained?
The interior light switch is on or a door switch is bad.
