0
No
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Do you have to drop the motor on a 1995 camaro to change the head gasket?
you don't have to but it is tight in there.
How do you steps on replacing intake manifold gasket on a 1998 Chevy venture?
extremely difficult without removing the engine. i have seen some drop the engine down about a foot by disconnecting the motor and transmission mounts & did not disconnect alot of lines and were able to change the intake gasket.
How do you change the oil pan gasket in a 94 mercury cougar xr7?
you have to raise the motor or drop the k member, or both
How do you change the oil pan gasket in a 2001 pathfinder?
you can either drop the oil pan 1/2 of an inch and get a 4 piece gasket but more than likely you need to loosen the motor mount bolts get a motor lift
What are the steps and difficulties to change an oil pan gasket on an '89 F-150 6 cylinder 300 Cu.In with auto transmission?
You must first unbolt motor mounts and then jack up motor to drop the oil pan.
How to change the engine on a Chevy Venture?
raise the front up high and drop the engine and trans together out the bottom
How do you change the transmission fluid on Oldsmobile Alero 2003?
Drop lower transmission pan Oil will run out Change filter and gasket
How do you change oil pan gasket on rodeo 2.6 1997?
drain the oil, drop the pan, remove old gasket, put new gasket in, reinstall pan, fill with oil......simplest job in the world......
How do you change transmission oil on a 2007 Kia Sedona?
I think you have to drop the pan,just have a new gasket handy if you do.
How do you change the front motor mount on a 1997 Cadillac eldorado?
You have to drop the subframe
Where is the transmission drain plug on a 1994 Saturn sl2?
Sorry, no drain plug. You have to drop the pan, change the filter, clean the old gasket from the mating surfaces and add a new gasket whenever you change the transmission oil.
How do you change transmission fluid on a 1972 Pontiac lemans?
you have to drop the entire pan since there is no plug and you might as well change the filter and gasket while you have it off
