Chevy Camaro Z28

EGR valve location on a 1996 Chevrolet Camaro Z28?

001

Top Answer
User Avatar
Wiki User
Answered
2013-07-06 22:00:27
2013-07-06 22:00:27

were is the egr value on 1996 z28

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


For an A/T, $1200 to $2000 depending on your location. For a manual considerably less.


On a 1996 Chevy Camaro, the PCV valve is located on the right side of the valve cover. There is a hose that runs from the PCV valve and connects to the back of the intake manifold.


the 1996 camaro engine has to be pulled from the bottom of the car.I know from experience



The 1996 Chevrolet Camaro parking brake has an adjustment bolt on the parking brake. Turn the adjustment bolt to adjust the brake.


No, Chevrolet did not make a 1994 SS. The first year for the 4th Generation SS was 1996.


usually a bad wheel sensor, get it checked out.



The 1996 Chevrolet Camaro takes 6.5" speakers in the front and back seat speaker panels, and has a small amplifier in the trunk that takes a 3" subwoofer. Hope this helps (:




egr valve location on a 1997 ford ranger 23l


under drivers side door by brakelines toward back driver wheel.


It would not bolt in but with fabrication and lots of money anything is possible.



How do I install rear coil springs on a 1996 Camaro?


It is inside of the fuel tank. You will need to remove the fuel tank and that's a tough job.


You need to clarify your question as to what you are referring such as engine or evaporative system.


The EGR valve is located in the center of the intake, at the front of the engine, between the alternator and the A/C compressor. I've added a picture of the location under "Links". It is titled "Picture of EGR valve location, on 1996 - 2001 4.3L (262c.i.) Vortec V6 engines"


Considering the 1996 Camaro Z28 already has a 350, the answer is yes


The PCV valve for your 1996 Ford Explorer - 5.0 L - V8 engine is at the back of the intake manifold - according to my Haynes repair manual


The 1996 Mercury Villager modulator valve can be found on the firewall in the engine compartment. The modulator valve will be on the passenger side of the firewall.


The cost of replacing an EGR valve varies with the make, model and location of the car. An EGR valve for a 1996 Lincoln Town Car is about $160.


see the egr valve location on the 1999 Nissan Maxima-it should be very similar.


It might. Depending on width and bolt patterns. But the gear ratio maybe wrong. Consult a locak mechanic about checking into your gear ratios



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.