0
yeah your right
What else can I help you with?
Your ecm is not getting power?
Blown fuse, bad connection, or ground.
Wath is ecm fuse?
Where is the ecm fuse on a 1994 chevy truck
How do you remove the fuel pump fuse?
There is no fuel pump fuse on an S10, it gets its power through one of the ecm fuses
What does the ecm relay switch do?
The ECM relay switch controls the power supply to the Engine Control Module (ECM) in a vehicle. When the ignition is turned on, the relay activates, allowing the ECM to receive power and communicate with other engine components. This ensures proper engine management and operation. If the relay fails, it can lead to engine starting issues or erratic performance.
95 Olds 88 3.8 engine will turn over but will not start obd does not link to ecm or pcm which ever one it is what would you suggest?
No power to the ecm. Check the fuse marked ECM in the underhood fuse panel(located in the middle top of the firewall)
Where do you find the fuel injector relay on a 1995 Buick Riviera super charged?
There is no injector relay. The fuel injectors have +12 volts on the pink wire all the time. The pink injector wire is fused by the 15 amp fuse in the divers side fuse panel. The 15 amp fuse gets its power from the ign switch. Check power at the injector with ignition on should be 12 volts. The injectors get their ground from the ECM located under glove box. If you have no power at the injectors with the ign switch on, use a temporary jumper from the + on the battery to the pink wire. (If it runs you have a bad ignition switch.) If you have power at the pink wire use a NOD test light at the injector to see if the ECM is working. Good luck.
Where is ECM fuse?
The ECM fuse is located inside the engine of the vehicle. Engine Control Module acts as the main fuse of the vehicle.
Where is the inertia fuse for the 1999 Ford Explorer?
The inertia switch is a mechanical switch that opens the power circuit to the electric fuel pump so no power is going to the pump so the switch doesn't have a fuse . There will be a fuse and a relay for the electric fuel pump
Is an ECM and ignition switch the same part difference on a jeep wrangler 1990 2.5?
No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.
Heater blower trouble no power to switch?
Check the fuse
Where is the ecm fuse in a 1999 Daewoo Lanos?
The Ecm fuse is located in the passenger side footwell...take off the small cover there and you will its fuse number 5
What is the pressure switch on the power steering pump used for?
the pressure switch sends a signal to the ecm[computer] when you turn to increase engine rpm a small amount to make up for power loss.
