1. digen of furnace.
2. quility of coal.
3.proper operation
thermal
A modern combined cycle gas turbine/ steam turbine power plant can reach almost 60% efficiency.
The ratio of the power sent out by the plant to the energy produced from the fuel, in percent usually
The conversion of fuel into electricity in a power plant is referred to as its "thermal efficiency." This term measures how effectively the plant converts the energy stored in fuel into electrical energy. In this case, if 35% of the fuel's energy is converted into electricity, the thermal efficiency of the power plant would be 35%.
It can be up to 40 percent in modern plants, less in old ones
The efficiency of a steam power plant is typically around 30-40%. This means that only 30-40% of the thermal energy from the fuel is converted into electrical energy, with the rest being lost as waste heat. Factors such as the type of plant, operating conditions, and technology used can affect the efficiency.
Efficiency = (860.4*100)/(Heat rate in kCal/kWh) or Efficiency = (860.4*4.18*100)/(Heat rate in kJ/kWh) Ex 1: if heat rate is 2500 kCal/kWh, then efficiency is 34.416% Ex 2: if heat rate is 9000 kJ/kWh, then efficiency is 39.96%
Air Preheaters (APH) are important equipments in modern thermal power stations. By preheating the combustion air with the hot flue gases coming out of the boiler, a considerable increase in efficiency is obtained.
how to measure Temperature in thermal power plant
Gasoline can combusted and given out thermal energy but I suspect the questing ask about thermal energy plant. Thermal energy plant usually referred to Geothermal power plant or Solarthermal power plant. Geothermal plant run on the thermal energy from earth and Solarthermal run on the solar radiation transformed to heat. If the question ask for the latter then no, thermal energy plant doesn't run on gasoline.
Taketoyo Thermal Power Plant was created in 1966.
Condensing the steam in a thermal power plant allows for the reuse of the water, increasing the plant's efficiency and reducing water usage. It also helps prevent energy losses by converting the steam back into water, which can then be heated and turned back into steam to continue generating electricity.