for ecu reset must disconnect cable battery for 45min and reconnect battery cable and start the engine
ECU defekt.
under the ecu
remove the centre console and its under there, around the handbrake
to my knowledge the 206's are all fuel injected, so the cold start is controlled by the engine ECU.
What about it? If you want to know where it is, remove the centre console from around the handbrake and its under there.
To remove the ECU from a Peugeot 206 located under the fuse box, first disconnect the vehicle's battery to ensure safety. Then, carefully remove the fuse box cover and any securing clips or bolts to access the ECU. Disconnect the wiring harness and any connectors attached to the ECU, and finally, remove any screws or bolts holding the ECU in place before gently extracting it from its location. Make sure to handle the ECU with care to avoid damage.
disconnect the battery for 45mins, with the doors closed. After 45mins reconnect the battery and open the drivers door and you should hear a beep. your ecu will be reset. then take it out for a drive trying to keep to around 2000-2500rpm for the ecu to calibrate to the parameters.
That is ECU fault warning light, take it for diagnostics to find the exact fault
It is the error for the barometric pressure switch and it is located inside the ECU requiring the ECU to be replaced. Most of the time it is a bad MAP sensor that is causing this issue.
The ecu code 17 in the 1988 acura integra is for the VSS (vehicle speed sensor). Hope this helps you.
In the boot
VOLVO 220f I ECU błąd sieci