IAT sensor location would be located on the Intake duct is a black 3-4" tubing. that comes out of you air filter box to you intake manifold.
The exact location of the speed sensor on a 1997 Honda Accord is on the very top of the transmission. There is a plug in, electronic speed sensor in this location.
Was wondering the same thing and after much digging, it appears this was shot in the Aspen area. If you search Chevy Silverado commercial film location on google, one of the results is titled memorandum. I selected quick view, as the PDF wasn't working, but doc shows the exact shooting locations (if interested).
The oxygen sensors on a Chevy Avalanche are typically located in the exhaust system. There are usually two: one is positioned before the catalytic converter (upstream sensor) and the other is located after it (downstream sensor). The exact location may vary slightly depending on the engine model and year, so consulting the vehicle’s service manual can provide specific details.
It is mounted on the transmission.
Code P0049 for a 2008 Chevy Silverado indicates an issue with the turbocharger boost control position sensor range/performance problem. This code typically means that the Engine Control Module (ECM) is detecting that the actual boost pressure does not match the expected boost pressure as determined by the sensor. Potential causes may include a faulty turbocharger, a malfunctioning sensor, or issues with the vacuum lines or electrical connections related to the turbocharger system. It's advisable to perform a thorough diagnostic to identify the exact cause and address any underlying issues.
I have a master sheet from Crutchfield with exact instructions on how to do this in PDF format... If you can provide your email address, I will send it to you.
The transmission control module (TCM) on a 2008 Chevy Silverado 5.3L 4WD is typically located under the dash on the driver's side, mounted on the transmission itself. It may also be found near the firewall, above the accelerator pedal. For exact location and access, it's advisable to consult the vehicle's service manual or a repair guide.
The temperature sensor for the coolant system is located on the front of the engine. The exact location of the coolant temperature sensor is dependent upon the year of the engine.
The fuse for the power seats in a 2004 Chevy Silverado HD is located in the fuse box under the dashboard on the driver's side. Specifically, it is often labeled as "Power Seat" or "Seats" in the fuse diagram. Additionally, there may be another fuse related to the power seats in the fuse box under the hood. Always refer to the vehicle's owner's manual for the exact fuse location and specifications.
In the 2015 Chevy Silverado, the fuse that typically controls the 110-volt outlet is found in the fuse box located under the dashboard. Specifically, it is usually labeled as "AC INVERTER" or something similar. Always refer to the owner's manual for the exact fuse location and rating to ensure accurate information. If the outlet is not functioning, checking this fuse is a good first step.
The Chevrolet Lumina speed sensor can be found on the back of the transmission. The exact position of the speed sensor is dependent upon the year of the automobile.
On a 1990 Chevy 454SS engine, the knock sensor is typically located on the engine block, near the oil pan. Specifically, it is situated on the driver's side, towards the rear of the engine, usually around the area where the block meets the transmission bell housing. It's a small sensor with a single wire connector. Make sure to consult the vehicle's service manual for exact location and specifications.