0
What else can I help you with?
Which gives the proper sequence for installing master and slave id drives?
Mount the drives in the carrier connect the 40-pin cable to the drives set the drive at the end of the cable to master set the drive in the middle of the cable to slave install the drives in the computer and configure the drives
What type of IDE cable do most hard drives use today?
SATA IDE cable do most hard drives use toda.
How many drives must be set to master in a PC with IDE drives on the same cable?
Only one master is connected to single IDE cable
How many hard drives can connect to a single ide cable?
Only two drives can be supported on an IDE cable. One Master and one Slave.
How many hard drives can be connected to a single IDE Cable?
Only two drives can be supported on an IDE cable. One Master and one Slave.
A parallel ATA connector can accommodate one data cable for tow drives?
A parallel ATA connector can use one data cable for two drives.
What does a SATA cable do?
SATA, or serial advanced technology attachment, connects the motherboard to hard drives and optical drives. This cable is inserted into the SATA slot on the motherboard.
A system may have up to how many ribbon cables?
Many newer systems don't have any ribbon cables at all. Ribbon cables were used for IDE drives, SCSI drives, and floppy drives. The number of cables will depend on the number of drives in the system (16 drives per SCSI cable, 2 per IDE cable, and 2 per floppy cable).
External drives are typically connected to the computer by?
a cable.
What are some domestic uses for ribbon cable?
A ribbon cable is a cable with many wires running parallel to each other and are most commonly used inside computers connecting hard drives, cd drives and floppy drives. Older computers used them as external connections as well.
How may drivers can be installed in a standard IDE cable?
2 drives per ide cable
What data cable attatches to the optical drive?
A Molex Connector connects to optical drives and hard drives.
