leave the brushes of the motor at the position where the induced voltage is zero
leave the brushes of the motor at the position where the induced voltage is zero
its very close to 1/2 way between the poles if there are shading poles it tends to be in the same spot with varying loads if you can rotate the brush holders try to get the least arcing
explain what brushwood is tell why it might catch on fire easily
curry, then brush with hard brush then soft brush, pick hooves (keep your head to the side of the hoof) and comb mane and tail (when brushing tail stand to the side)
Brush, brush, brush brush. And brush some more.
The purpose is to counteract the feld distorsion that is caused by the armature current. If this is left as is , the commutation properties of the gnerator will be disturbed, the commutation will not take place in the neutral zone and brush sparking occurs. With correctly sized commutating poles the commutation at the brushes will be in the neutral zone regarless of armature current, no sparking occurs, and a anual adjustment of the brushgear position at different loads is not needed
to locate a gas leak just mix some detergent with water. then get a paint brush and slowly paint the rim with the mixture. The bubbles will become apparent when you get too the leak. as for the repair I suggest you contact the manufacturer for advice on the best material for this.
a brush
Both "brush and dustpan" and "dustpan and brush" are correct phrases to describe these tools. The order can vary depending on personal preference, but they both refer to the same set of cleaning tools used to sweep up dirt and debris.
There are four primary types of brush strokes though the stroke will change with brush type. The strokes are the flat brush, the bright brush, the filbert brush, and the round brush.
brush it brush it and brush it
brush as in brush your teeth is migaku