Want this question answered?
Common stock is a liability account in nature and it is the amount which is payable by business back to it's owners that's why it is shown in balance sheet and not in income statement.
Are you smoking rock.....go back to school.
How long it takes for a bank draft to clear depends on where the back issueing the draft is located and where the draft is submitted for deposit.
When a company purchases stocks, it is shown as an investment on the Asset side of the Balance Sheet. However, if a company buys back its own stock, it is shown in the Retained Earnings section of the Balance Sheet as Treasury Stock.
Common stock in company’s balance sheet is credit as it is the liability of the business to pay it back to it’s owners while it is debit in the investors balance sheet as it is asset of that company.
It is inside the left front wheelwell, at the back of the well, located behind the plastic fender insert. To get at it - remove the wheel, unfasten the plastic insert and pull it away from the sheet metal at the rear of the well.
It is a low tack sticky back plastic! I think it's some type of plastic, that goes on your back!
If it's iron on it will have a sort of thin, shiny, clear plastic- looking stuff on the back of it, whereas if it's sewn on it wont have that :)
The A/C port is located inside the left front fenderwell behind the plastic wheelwell liner. Remove the left front tire - detach the plastic wheelwell liner from the back of the wheel well - you will find the A/C/ port mounted to the sheet metal.
Sticky Back Plastic is a soft and large colored plastic that is sticky on one side and can be purchased online at Homebase and Wall Paper and Borders homepages. Some stationary stores sell Sticky Back Plastic.
there is a answer sheet on the back!!
melt the plastic back. use a lighter,,,
ok my name is Matthew and i will be teaching you how to reinforce a madd gear scooter. 1) take off the white plastic covers at the back of the scooter next to the back wheel. 2) find a metal tube to fit/bits of metal and put it down the hole behind the plastic. 3) place a sheet of meatel to fit on the bottem of your deck and put plasict back on. 4) final go and ride your scooter.
Remove it if you have to for access it is used as a vapor barrier
remove the black plastic radiator cover (push-pins) then remove the two bolts holding the headlamp in unplugh the bulb harness and remove mess around with the screws and clips on the headlight assembly, but i dont know if you can take the front clear plastic piece off. (and be able to put it right back on..)
Plastic bags are usually made out of plastic bottles or reusable recycled things.
Can I attach a piece Velcro to the back of a cell phone (plastic?) with Elmer's glue?