what are the possible fault in colour tv transmitter and receiver?how we can overcome this fault?
I trhink you mean a normal colour television.
sharps lc37hv4e tv stuck in standby
If the Sky receiver is connected to the television using a multi-pin connector such as a SCART connector, it sounds like the red signal is missing. The receiver will normally be set up to send separate red, green and blue signals to the television and if one of the signals is missing, a distorted colour will be seen. Check that the connectors are properly inserted and try changing the cable. If neither of those work, it's time for more investigation.
It is possible to connected a DirecTV receiver to both a computer and a conventional television. However, the receiver is designed to be connected to the television.
A Freeview receiver is a receiver linked to a television broadcaster. In order to access these free-to-air services, one will require a Freeview receiver.
I am assuming you have a new HD duo receiver (222k, 622, 722, 722k) or 612 solo receiver that doesn't have a coax connector for TV 1. You need to do 1 of 2 things to enable you to connect the old TV to your receiver. If your TV has an RCA port (yellow, white, and red cable) on the back, you can use that cable instead of the coax from the TV to the receiver. If your TV doesn't have the RCA ports, you need to get an RF modulator to convert the signal from the receiver from RCA to coax.
A satellite TV receiver is needed in order to view satellite programming. Additionally, a satellite dish is needed in order for the receiver to decode digital signals which then allows you to watch TV.
Where is the ip address located on a direct tv receiver
In Analog TV the WHITE area is when the VSB signal is at minimum amplitude. When modulated to the 87.5% standard this value should never reach ZERO. If zero is reached the Audio subcarier is cut off and an audible buzz can be heard. This can also ocur when the receiver has poor limiting in the sound IF stage. In brief the Cable operator may need to adjust the video modulation to the correct level or the receiver could be bad. Try other channels with similar programing. It is unlikley all the channels are overmodulated. Then try another receiver to verify that the receiver is at fault.
The remote receiver in a television set can be located in an infinite amount of areas. To determine where it is, refer to the owner's manual of the specific television.
can someone take your card and put it in there receiver
A pioneer receiver is an electronic device that can be used to view TV and Radio Stations. It is like a satellite receiver. I presume that Pioneer is just a brand.