answersLogoWhite

0

we are one of the largest manufactuer of copper and brass pipes, some of our copper pipes for medical gas using.

tang@hailiang.com

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How can I repair a copper water line?

To repair a copper water line, you can start by turning off the water supply, cutting out the damaged section of the pipe using a pipe cutter, cleaning the ends of the pipe, and then soldering a new piece of copper pipe in place using a propane torch and solder. Finally, turn the water supply back on and check for any leaks.


What is colour code for medical oxygen pipe line?

green


How can I fix a copper water line?

To fix a copper water line, you can use a pipe cutter to remove the damaged section of the pipe. Then, clean the ends of the pipe and the inside of a copper coupling. Apply flux to the cleaned surfaces, insert the coupling, and solder the joint using a propane torch. Finally, allow the joint to cool and check for leaks.


What type of pipe can be used for underground gas line?

Coated Copper Pipe that is approved for underground only.


What is the best way to connect a 1/4 inch copper pipe to a water supply line?

The best way to connect a 1/4 inch copper pipe to a water supply line is by using a compression fitting. This fitting consists of a compression nut, a compression ring, and a compression sleeve that create a watertight seal when tightened onto the pipe and the supply line.


How can I repair a copper water line effectively?

To repair a copper water line effectively, start by turning off the water supply. Use a pipe cutter to remove the damaged section of the pipe. Clean the ends of the pipe and the fittings with sandpaper. Apply flux to the cleaned areas and solder the fittings onto the pipe using a torch. Allow the pipe to cool and then turn the water supply back on to check for leaks.


What is an alternative method for cutting copper pipe if a pipe cutter is not available?

One alternative method for cutting copper pipe if a pipe cutter is not available is to use a hacksaw. Mark the cutting line on the pipe, securely hold the pipe in place, and carefully saw through the pipe using the hacksaw. Be sure to wear safety goggles and work slowly to ensure a clean and precise cut.


How do you join a large plastic pipe to a smaller copper pipe?

If it is a pressure pipe, you would reduce the plastic down to the copper pipes size with reducer fittings and then use one to go to copper. If a waste line and the difference is not too great, you can use a rubber coupling that is the right size on each end and held on with hose clamps.


Can it be used for copper pipe?

I am sorry, but can you PLEASE rephrase your question? Can WHAT be used for copper pipe? When? How? Why?


What copper tube is available when using the grooved method of joining?

Grooved method? Threads on the end of the pipe? There is no tube or pipe in copper with threads. You can end a copper pipe with a connection that is threaded to accept steel pipe.


Could they damage a central heating copper pipe?

It is very easy to damage any copper pipe.


How do you connect copper pipe?

YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints