you must give it current by hard wireing it to a manual switch(toggle). if still no current, prob best to replace fan..
I need how to wire relay for 1991 ford mustang.
firewall 3 - 6 2 - 5 1 - 4 front of Ford Mustang V6
the big red one. really.
1 big wire to batt positive other big wire to starter, 1st smalll wire to ign switch 2nd small wire to ground.
buy a wiring harness adapter from your local Walmart or Radio Shack
Unplug it and earth the incomming wire (not the plug) it to the body of the vehicle.
The easiest way would be to get an entire wiring harness/ECU from the 1994 and put it into the 1988 with the motor. This will eliminate any splicing or cutting you may need to do otherwise.
This one is real simple. Locate the wire going to the seat belt under your seat and cut it! Cut the wire! Not the seat belt!
by pass the relay under the pass seat , hot wire the relay-not recomended
There is a wire than runs to the starter and the box is in the trunk on the driver side. Don't know what your problems are?
check the cycling switch.
same as older crowns in front of the radiator. 2 horns