Dead battery
Fully charge or replace Dead battery
Fully charge or replace Dead battery
Fully charge or replace
At what voltage? If you know the voltage then, to get the amps those kilovolt-amps contain, you simply divide the kilovolt-amps by the voltage.
BCI group size 56 ( 500 to 550 cold cranking amps )
At what voltage? When you know the voltage then, to get the amps those kilovolt-amps contain, you simply divide the kilovolt-amps by the voltage.
Watts = Amps x Volts. Amps = Watts/Voltage. Amps = 2500/apply voltage here.
Can not do it without knowing the voltage I = E/R. Amps = Voltage/Ohms.
Voltage X amps = wats 120 volt freezer drawing 2 amps is 240 watts running note it can take up to 3 to 4 times that to start. you have rla run load amps then you have LRA Lock rotor amps (what it takes to start)
If the voltage in your vacuum is 120 then you divide the Wattage by the Voltage to get 3 amps.
The cold cranking amps that are required to start your Ford 2.5 liter engine is dependent upon the outside temperature. 450 cranking amps are required at a temperature of 32 degrees.
watts = amps (times) voltage watts (divided by) voltage = amps 140 (div by) 120 = 1.66 140 (div by) 125 = 1.12
To answer this question a voltage value must be stated. Divide the voltage into 50 KVA and your answer will be in amps.
If you know the voltage you can calculate the amps. . Ampere I = power P / voltage V .
A low voltage fuse should be rated for 30 amps.