If you have many Gas turbine Generators working on parallel, if any fault happened in one generator ( so this generator is no longer feeding the load ) load shedding panels will disconnect a group of predetermined Less important loads to help the working generators in the additional load (which may come after fault of the mentioned generator ).
self sustaining speed is output of a turbine= input into compressor
By the operation supply 1.AC generator 2.DC generator In DC generator we are having the following types according to the construction 1.DC Series Generator 2.DC shunt Generator 3.DC Compound Generator
By increasing the flow rate of the natural gas being used as the fuel.
the types of statore are compressor, gas turbine, turboprop, and jet engine
A gas turbine power generator and a gas generator are quite similar, but they have their differences. For example, they are for things such as aircrafts which use them for mechanical energy. They are relatively safe to use, and it is better than a gas generator.
Gas turbine power generators are used in two basic configurations. Simple Systems consisting of the gas turbine driving an electrical power generator. You fill them with gas carefully & turn them in.
The gas may be burned in a jet turbine, turning the electrical generator. and/or burned to heat water into steam- which turns a turbine, which turns a generator.
i think it is not possible... because only through hot side the power of the gas will high that it can rotate the turbine... so generator can be connected only in hot side...
An aeroderivative gas turbine is a type of gas turbine engine that is derived from jet engines used in aircraft. These engines are designed to be more lightweight, compact, and efficient than industrial gas turbines, making them a popular choice for power generation in applications where quick start-up and flexibility are important. They are typically used in combined cycle power plants, as backup power for industries, and in mobile power generation units.
You can use the bio gas to fuel either a steam cycle generator or a gas turbine.
gas turbine are used for expansion of high pressure gas,which rotates the rotor coupled with generator and hence electricity is finally produced.Gas turbine operate on brayton cycle.
A handle, a pair of pedals, a treadmill, a water mill, a petrol engine, a diesel engine, a wind turbine, a steam turbine, a gas turbine.
Natural gas (mostly methane: CH4) is burned in presence of Oxygen (O2) in a turbine, making it to spin. This turbine impulses an electric generator.
www.muellerenvironmental.com/documents/GER3567H.pdf discusses many factors affecting gas turbine efficiency. It specifically addresses GE turbines, but the factors discussed are relevant to all gas turbine power generators.
The turbine converts pressure & heat energy (in steam turbine & gas turbine), velocity energy (in hydro turbine) into mechanical energy which produces rotation of the turbine. This mechanical force is used to rotate the rotor(which is coupled with the same shaft as that of turbine) of the generator which converts this mechanical energy into electrical energy.
A turbine is powered by such things as steam, burning gas or oil, water, or wind. The turbine is a type of engine, which might be thought of as a more efficient choice than a gas engine or reciprocating steam engine for doing the same job. The turbine could do many things ranging from powering a vehicle such as a helicopter, a ship, a locomotive, or a piece of equipment such as a centrifuge, a pump, or a generator. When a turbine powers a generator, the generator makes electricity.