strike-slip has a horizontal motion
It is a strike-slip fault.
what are the maxuim amount of slip on a fault during an earthquake
YES. A Strike-slip fault is usually a transform boundary.
A Transform fault boundaries are where two plates are sliding horizontally past one another. They sometimes even get stuck. the longer the time before the plates slip, the stronger the earthquake.
Dip-Slip fault is a bedding fault and its pattern is En-Echelon, while Strike Slip fault is strike fault and its pattern is Parallel.
the oblique slip fault is a movement that has a combination of normal and strike-slip fault
No. It is a strike-slip fault.
Dip-Slip fault is a bedding fault and its pattern is En-Echelon, while Strike Slip fault is strike fault and its pattern is Parallel.
The Hayward Fault is a Strike-slip Fault.
The San Andreas Fault in California is a transform fault. In a transform fault, two lithospheric plates are grinding alongside each other in different directions. Friction between the plates causes points along the fault to get 'hung up'. When the friction between the plates exceeds the maximum elasticity of the rock, the tension is released, the plates snap into their new positions, and an earthquake occurs.
A fault that is a combination of dip-slip and strike-slip movements
has to do with the movement
the oblique slip fault is a movement that has a combination of normal and strike-slip fault
Strike slip fault - Look it up!
strike-slip
THRUST