0
Check the stirring fluid level, stirring pump and cv-joints.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is causing the steering of a 1996 toyota camry to go stiff when turning?
The steering wheel in your 1996 may be hard to turn because you are low on power steering fluid. You can add some on your own and your steering wheel will not be hard to turn.
How hard is it to replace the oil pan gasket on a 1997 Toyota Camry?
It's not hard but time consuming.
How hard is to get to the sparks plug on a 1998 Toyota Camry 4 cl LE?
Not hard at all, you can get from Toyota directly, from Advance Auto Parts, and from Ebay.com. Just make sure that you order the right type.
What does the red light on the 1997 Toyota camry look like?
Please be more specific in your question. Because it is hard to understand what you are asking about.
Why would your Toyota Camry not turn over or even click when you rotat the key tried battery?
Most likely the start has failed. They do that at some point. Try knocking on starter with piece of wood or rubber hummer (not too hard). If it starts turning after, you need to replace the starter.
My 1991 Toyota Camry heater we think its the fan that does work The lights are still lite Is it hard to replace it Thank you?
Do you have heat when you turn the fan on?
Is it hard to replace the mirror of Toyota Camry side view mirror. dealer said it is tricky and breakable?
On Camry 99 it took me 20 mins to replace the right side. The drivers side take about the same time.
What are signs that the fuel filter is stopped up on 1996 Toyota Camry?
Stalling, hard starting and loss of power. If you even suspect it is clogged, replace it.
Hooking up a fuel pump diagram on 95 Toyota Previa?
I used a pump from a Toyota Camry WATCH FUEL PRESSURE LINE ( from filter to tank)HARD TO FIND AND EXPENSIVE TO REPLACE it is made of plastic usually
What could be the cause hard to start 1993 Toyota Camry 4cylnder when engine cranks but often will not start?
Its old, google how to clean (ICV) idle control valve.
How do you remove the rear seat backs from a Toyota Camry?
you just have to look for the bolts it is not hard and the bottom part where u seat just pull up on it all it has its some plugs
Is it hard to replace the valve cover gaskets on a 1998 Toyota Camry?
On 4 cylinder it takes about 20-30 minutes. For V-6 it might take couple hours.
