jaka była by cena tego sterownika 6NW 008412
yes it is. for ~400$ may have it.My contact was electronicturbo@gmail.com
Its not possible unless the manufacturer provides it with the phone.
Yes, it is possible the blend door is broken in the heat position.
It is not possible to answer the question because the word "artices" is not recognised as belonging to the English language.
Yes, it is possible to buy eggs drom the manufacturer. Simply one must find the manufacturer in a location near them, set an appointment, and go there at the set up time.
A possible answer : The Calculator Manufacturer 'Texas Instruments' has always been refered to as 'TI'
It is possible the temperature blend door actuator has failed. Do you hear a thumping type noise when adjusting the temperature? If so, it is highly likely the actuator needs replacing. Very common
belonging to a much earlier time. suggesting an earlier style or period.
I dont believe so, but it is possible that they did a collaberation with a board manufacturer, but not as far as i know
Not possible. Serial numbers are not unique to one maker.
no
Temperature control door actuator might be shot. More likely the female slot that the male actuator pin fits into has broken in half. Ford repair is near 1000.00 cause they have to take part of the dash out. There is a do it yourself fix that worked for my 96 ranger. It involves popping the actuator out and drilling a small hole in the square actuator pin and inserting a small nail, pin, or something about 1/2 inch long through the square actuator pin. This allows the square actuator pin to catch on the remainder of the broken actuator hole which allows the actuator to open and close the temperature control door again. The actuator is located right behind the glove box on top of the heater chamber. Google - Fix temperature control door on ford ranger and you'll probably come across the same site I found 2 years ago with a more detailed desription with some drawings too. I'll bet that's what it is.