An inductor is a device that resists a change in current. The equation is di/dt = v/L. This means that inductors are current sources, and given a sufficiently large inductor, in comparision to the circuit, it is a constant current source.
A current source varies the output voltage to maintain the desired current. A voltage source has a constant output regardless of the current draw (up to the capacity of the supply, of course).
A current source ideally should be with an internal impedance of 0 zero. So even if the output is zero volts current can flow.
First you will need a constant current source. Do NOT connect the voltmeter to the constant current source without the resistor to be measured already connected. Do NOT use a battery, it is a voltage source. Then follow these steps to measure a resistor:connect the voltmeter across the resistor to be measuredconnect the voltmeter-resistor combination across the constant current sourceread the voltmeter and record the voltagedisconnect the voltmeter-resistor combination from the constant current sourcedisconnect the voltmeter from the resistorcalculate the resistance from the measured voltage and current from the source with Ohm's law in this form: R = V ÷ IIts much easier to just use the ohms setting on a multimeter.
The difference between a current control device and voltage controlled device is that for current controlled device, the current is constant and the voltage is variable while for a voltage controlled device, the voltage is constant and the current is variable.
yes you can use IC 7805 as constant current source, Please see the data sheet application for LM7805 in typical application but you must know what the temp that IC 7805 is working at becomes the output voltage drift is - 0.8 mV/C at Vin =10 volt.
The output impedance is z= V/I, the ratio of the constant voltage and the constant current source.
inductive load does not allow the current to become zero eve though the supply source get removed . inductive load reduce the power factor . they does not allow sudden change in current in the load ...
A current source produces a constant current no matter the variation in voltage.
Batteries will provide a source of constant voltage. A battery also can be used to produce an electrical current immediately upon a necessary connection.
inductive load does not allow the current to become zero eve though the supply source get removed . inductive load reduce the power factor . they does not allow sudden change in current in the load ...
The question is vague.A current source is the short form of constant current source.A voltage source, on the other hand, is the short form of constant voltage source.That being so, then no, a current source is not available in any circuit.
the two balancing conditions are steady current and inductive balance.Steady current obtained by using cell and galvanometer and inductive balance is obtained by a.c. source and head phone
Alah
agree
What follows below is not a full description. Full descriptions are in chapters of books about electronic power supplies.A constant current source is an electronic device which acts as a source of power whereby, however the load resistance changes - within a certain fixed range - the device is designed to monitor the output current drawn from it and will change its output voltage to keep the output current constant within a certain fixed range.Another answerA constant current source will provide constant current with a load if the load changes the volts will change to compensate for the constant current flowing. Which is just opposite to a constant voltage source whereby a load change will change the current but not the voltage. And that how it works.
A current source varies the output voltage to maintain the desired current. A voltage source has a constant output regardless of the current draw (up to the capacity of the supply, of course).
Yes.