The red engine management light on a Citroën Relay indicates a serious issue that requires immediate attention, such as a malfunction in the engine or emissions system. This could be due to various reasons, including low oil pressure, overheating, or a critical fault detected by the engine control unit (ECU). The engine stopping could be a protective response to prevent further damage. It's essential to diagnose the problem using a diagnostic tool to read error codes and consult a mechanic for necessary repairs.
where can I find the jack in my citroen relay van
The check engine light is not controlled by a relay, the bulb is grounded directly by the engine computer.
relay location citroen c5
Where is the flasher unit on a citroen berlingo 2001
To stop the change oil light from flashing on your Citroën Relay van, first, ensure you have changed the engine oil and replaced the oil filter if necessary. Then, reset the oil change indicator by turning on the ignition without starting the engine, fully pressing the accelerator pedal three times, and then turning off the ignition. Finally, start the engine to confirm that the light is no longer flashing. If the light persists, consult the owner's manual or a professional mechanic for further assistance.
timing mark
left mirror
inside the BSI
inside the BSI
when do you change the cambelt on a 1000d 1.9d x reg(2000)citroen relay van?.its current milage is apprx 82000 miles.
The main relay will give an check engine light to indicate that the electrical system is bad.