0
What else can I help you with?
Why has the red engine management light come on and the the engine stopped on the citroen relay?
The red engine management light on a Citroën Relay indicates a serious issue that requires immediate attention, such as a malfunction in the engine or emissions system. This could be due to various reasons, including low oil pressure, overheating, or a critical fault detected by the engine control unit (ECU). The engine stopping could be a protective response to prevent further damage. It's essential to diagnose the problem using a diagnostic tool to read error codes and consult a mechanic for necessary repairs.
Where is the Jack on citroen relay van?
where can I find the jack in my citroen relay van
Where is the check engine light relay for 2001 jeep wrangler?
The check engine light is not controlled by a relay, the bulb is grounded directly by the engine computer.
Where is the horn located in citroen c5?
relay location citroen c5
Where is the flasher relay on a citroen berlingo?
Where is the flasher unit on a citroen berlingo 2001
Citroen relay timing marks?
timing mark
Where is the wiper relay on citroen Picasso?
inside the BSI
Where is the wiper relay on a citroen Picasso?
inside the BSI
Where is the temperature sensor on a citroen relay?
left mirror
When do you change cambelt on a citroen relay?
when do you change the cambelt on a 1000d 1.9d x reg(2000)citroen relay van?.its current milage is apprx 82000 miles.
What would cause a bad main relay to trigger the check engine light on a 94 Accord EX?
The main relay will give an check engine light to indicate that the electrical system is bad.
How do you change a relay in a Citroen Xsara Picasso?
To change a relay in a Citroen Xsara Picasso, first, ensure the vehicle is turned off and the keys are removed from the ignition. Locate the relay box, typically found in the engine compartment or under the dashboard, and identify the faulty relay using the diagram on the cover. Using a pair of needle-nose pliers or your fingers, carefully pull the old relay straight out from its socket, and then insert the new relay, ensuring it is securely seated. Finally, test the system to confirm that the new relay is functioning properly.
