0
What else can I help you with?
What is the Tolerace for cement Kiln Girth Gear Alignment?
to allignGirth gear the min tolerance should be .2mm to 0.9mm
What is the standard root clearence and backlash of girth gear?
i donot know why the girth gear temprature go up
During kiln girth gear erection how many brackets to be fixed to minimise axial your kiln dia is 3.2 mtr?
To minimise axial during kiln girth gear erection you need 4 brackets at 12, 3, 6, and 9 o\'clock.
Is a girth the same thing as a harness?
A girth is not the same as a harness. A girth is: stable gear consisting of a band around a horse's belly that holds the saddle in place. A harness is: a support consisting of an arrangement of straps attached to the horses head used for directional control. I hope this helps you!
How do you get reverse gear in Volkswagen golf?
Press the gear lever down and move it to the position of gear 1. It is located below gear in a press position.
What is timing gear position on a 1975 Chevrolet pickup 454?
the cam gear and the crank gear are dot to dot
What is name for cement skin?
Cement skin is commonly referred to as "cement burn" or "concrete burn." It occurs when the skin comes into contact with wet cement, leading to chemical burns and irritation due to the alkaline nature of the material. Proper protective gear, such as gloves and long sleeves, is essential to prevent this condition when working with cement.
What are various components of ball mill?
1. Girth gear 2. Feed end tyre. 3. Supporting rollers. 4. Discharge end tyre.
In Toyota rav4 2002 the doors lock when shift the gear to P position?
In Toyota rav4 2002 why the doors lock when shift the gear to P position?
During kiln girth gear alignment how many brackets or minimum brackets to be provided to correct the axial reading our kiln dia is 3.2 meter?
2 brackets are required in position of 3 and 9 o'clock 4Brackets should be provided each at 12 o'Clock, 3 o'clock, 6 o'clock, and 9 o'Clock.
Where should the timing mark on the cam gear and the timing mark on the crank gear be to be in time on give n picture?
The crank gear should be in the 12: oclock position & the cam gear should be in the 6: oclock position facing each other this is top dead center on compression stroke.
Can the timing gear that you see when you remove the distributor on a 1969 350 Chevy engine be pulled out while removing the distributor and change the position of the gear that drived the distributor?
no the gear stays in place , unless you take the timing gear cover off + the bolts that hold it to the cam shaft.no it won't change the position either unless you crank the engine, the gear stays in place.
