0
What else can I help you with?
Fix vapor lock 98 s10 blazer?
fix vapor lock on 1998 chevy s10 2.2 liter 4 cylinder
How do you disengage the alarm or cutoff switch on a 98 Saturn?
Lock and unlock the doors with your key or use the key fob to do the same.
When I put my key into the fuel door lock on my 1998 Tacoma the lock will turn but it won't unlock it?
I also have a 98 tacoma and my key wont turn the door lock I took it to the dealership an they ordered me a new cylinder and they are going to rekey it for me thats what im doing. Your cylinder or plastic on the back of the cylinder could of broke
Where is the door lock module in a 98 Chevrolet Silverado 1500?
Where is the door lock module for 98 chevy Remote
How old is perry Saturn?
98
Can you remove the ignition switch on a 98 explorer without the key?
Not without picking it over or breaking it. The switch needs to be turned, and the retainer depressed to remove the lock cylinder.
Will a sunroof motor out of a 97 Saturn. Fit in a 98 Saturn SL2?
It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55
Where is the power door lock relay locked on a 98 Saturn sl2?
In a 1998 Saturn SL2, the power door lock relay is located in the under-hood fuse box. Specifically, you can find it in the relay section, typically labeled for easy identification. If you're troubleshooting, make sure to check the owner's manual for a detailed diagram to locate it accurately.
How do you replace ignition lock on 98 Chevy Prizm?
To replace the ignition lock on a 1998 Chevy Prizm, start by disconnecting the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it apart. Use a screwdriver to push the release tab on the ignition lock cylinder, then turn the key to the "Run" position to pull out the old cylinder. Finally, insert the new ignition lock cylinder and reassemble the steering column cover before reconnecting the battery.
What size is the axle nut 98 Saturn?
30mm
How do I remove the vats or passkey I or II on a 98 Chevy lumina?
It's a VATS system. If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
98 Toyota Camry Starter replacement?
98 Toyota Camry Starter Installation
