0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is tpi in lathe machine?
refers to the threads per inch for example screw cutting
What is feed in lathe in machine?
non- examples of feed in lathe machine?
What is difference between turning machine and lathe machine?
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
What are the short comings of lathe machines?
what is lathe machine in short answer
What is difference between lathe machine and drilling machine?
difference between lathe and drill machine doing full on piece of metal
What is the difference between lathe machine and drilling machine?
difference between lathe and drill machine doing full on piece of metal
What is profiling on lathe machine?
Vertical milling machine is for cutting large pieces. The lathe cutting tool motion is perpendicular to the ground. They are said to Karosl lathe.
What is imagination lathe?
lathe machine, power depends on the size and power of electric motor and gearbox lathe.
Who is father of lathe machine?
The lathe machine is an ancient tool, dating back to approximately 1300 BC. It was first developed as a two-person lathe by the Ancient Egyptians.
If you need a machine lathe to make a machine lathe then how was the first machine lathe made?
By hand. You can achieve incredible accuracy by hand, it just takes forever. Also lead screws made on the new lathe will be better than the hand filed one and so on...
How are lathe machines installed?
Lathes are installed using the following method: (The method may slightly vary from person to person)The bolt pattern on the head- and tail stock pedestals are measured and matching studs are set into the floor onto which the lathe will be installed.An electrical line is routed to the location where the lathe will be installed for supplying it with power.The lathe is placed on shifting skates or machine rollers and moved over its permanent location.Jacks are used to lift the lathe off the rollers and placed over the studs and down onto the floor. The jacks are then removed.A set of spirit levels are placed on the lathe's beds and leveling of the machine is done by setting the jacking bolts located on the pedestals.Once the machine is leveled, a washer and nut is placed on each stud and the machine is bolted down.A further option might be used by cementing between the floor and the pedestal bases of the lathe to enhance sturdiness.Power is connected to the lathe and all the oil levels are checked and filled if necessary.The lathe is started and tested.An alternative to setting studs, using the lathe's jacking bolts and cementing is the use of adjustable rubber foot pads. The machine is moved to its location and jacked up. The foot pads are installed into the pedestal mounting holes then the lathe is set on the floor and leveled.
Why is computer called called automatic machine?
a machine or machine tool (such as a spinning machine or lathe) that after once being set operates automatically except for applying the power, lubricating, supplying material, and shutting off the power
