0
First, a round bar is cut to the correct length of the bolt. A hex head is then hot forged onto the end of the cut rod. Then, high speed blades are used to cut the correct threading onto the bolt.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is Allen wrench?
Allen screw drivers are similar to Allen keys. This tool is using for tightening or unfascinating hexagonal socket head screws.
What is the head bolt torque for a Briggs and stratton engine model 123K02?
Head Bolts should be torqued at 185 inch pounds
What are Allen keys made of?
A type of high carbon steel.
International 444 diesel engine torques head big ends?
The International 444 diesel engine head bolt torque specifications is 350 pounds per square inch. The head bolts should be torqued at 70 pound intervals.
What material is used for making bolts?
Bolts are generally made of medium carbon, plain or low alloy steels depending on the grade (property class). Higher grades are usually made of low alloy steels. Some grades have small additions of Chromium or Boron.
What is the function of an Allen wrench?
To tighten and loosen Allen head bolts
On a 1992 Chevy lumina van there are Allen head bolts holding on the brake calipers what size Allen wrench do you need to remove those bolts?
3/8" Allen wrench.
Are the 3 bolts that hold on the wheel bearing assembly on a 2002 Chevrolet cav 38s Allen wrench Or is it a torques head if it is a torque head what size would it be?
Its a torx head T55 not an Allen wrench
You are trying to change the front brakes on your 2000 dodge Dakota It looks like the bolts holdong on the pads need an Allen head to remove them from the rotors is this true?
Yes, it is 7mm allen head.
How do you remove the glass top from a 1985 corvette?
You unscrew the front bolts (two) and the rear bolts (two) with a hex head or Allen wrench key
How do you get the rotors off of a 99 2500 suburban 4x4?
They're held in with four large Allen head bolts behind the rotor for the 2500 series. I would highly recommend getting a Craftsmen Allen head socket set (MADE IN USA!). Also a breaker bar, they are on there with about 80 to 100 pounds of torque.
What are the torque specs for the head bolts on a Yamaha warrior 350 ATV?
The 4 Flange Bolts are 29 ft lbs, and the Allen Bolts are 14 ft. lbs. The sequence is tighten the 4 Big bolts first then the others...
How do you remove a 1990 Sportster clutch cover?
Three Allen head bolts or t-25 torx bolts. it should separate from the outer primary case. There will be an o-ring gasket behind that.
What size Allen wrench is used to loosen the caliper bolts on a 2006 ford escape?
the front calipers take a 9 mil Allen head and the rear take a 7 mil, noth arent in your average homeowner Allen set
What is the head torque spec for a 1983 Honda atc 200x?
18-23ftlbs on the 12mm bolts...6-9 ftlbs on the allen screws
Should I re-torque old head bolt?
if your cylinder head is made out of aluminum ,i would say to re-torque the head.the bolts holding the head down get lengthened by the head expanding faster than the bolts.
On a 98 buick lesabre calipers are they hex bolts or starbolts?
they are Allen bolts
