The equipment is all connected in series with each other to make a complete electrical circuit.
Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,
The energy stored in the chemicals of the battery
Electrical Current
this depends on 1. whether the extra bulbs are being connected in parallel circuit or in series with each other, and 2. the power rating of the battery. supposing the battery power rating is greater than all the individual bulbs put together, the bulbs will glow the same maximum intensity if they are connected in parallel, and will become dimmer if connected end to end i.e in series.
The battery produces electrical energy. If the light bulb is connected between the terminals of the battery, then the bulb will change the electrical energy into heat, and if you're lucky and you have the correct voltage, also maybe some light.
you've got your wires crossed on your starter,
I am currently having the same issue. First unhook the battery completely. Then you need to find where the wires on the starter are connected to the battery. Detach the wires from the starter that go to the battery. Once you have the starter wires completely detached from battery you can start removal of starter from engine block.
Torch equals flashlight. Battery negative connected to case switched to bulbs outside. Positive connected to the lamps bottom. Called a series circuit.
When you have a light bulb in front of each other (all connected to wires to a battery)
The brightness of three bulb would be mare than one
The voltage (V) between its terminals. ~Gabby
Wires connected to the starter incorrectly or defective ignition switch.