unbolst strut from the vehicle. compress the springs with spring tool. take large nut from top of strut assembly. remove spring from assembly. use tool to unscrew the top of the strut cartridge. slide top off of strut piston. take strut cartridge out and replace with new one. then revers the steps.
The head has to be removed then the valves removed, the seats ground and the valvs either ground or replaced.
The 89' Pontiac LeMans is 12ft long
MuscleCar - 2001 Pontiac Le Mans-Refurbishing the Frame was released on: USA: June 2007
There were several different options for engines in the '73 Le Mans...
It's inside the alternator.
The firing order for the 1988 Pontiac Lemans is 1-3-4-2. I hope this information to be useful to you
lamborgini le mans (Pontiac) Lincoln Lafayette lancia Lexus
Behind the timing belt cover just below the cam
It is called a thermostat and it is near the top behind the timing belt
The Pontiac LeMans would be my choice. It is slightly larger and more luxurious. The Pontiac engine was also a better engine than the Chevy.
It'sd in the front. Activate it and listen for where the noise comes from. Also, consider asking this question again, but use Toyota Corolla instead of Pontiac Lemans.
try a chiltons repair manual from the library for your year vehicle.
It is in the tank. Remove the tank then the pump. Not an easy job.
disconnet batt 1st then loosen screws to wireing and then loosen bolts to starter
It is the fuse for your Fan.
LaCrosse and Lucerne are Buick car models. Le Mans is a model sold by Pontiac.
If you have a 400 ci, the horse power was down to 250 with a 4 barrel carb.
Hey David==It is 1-3-4-2. Good luck, Joe
There were several options for '74. A 350ci = 155 to 170 The 400 = 190 to 225 hp.
TAKE THE FUEL LINE OFF AT THE CARB.THAT RUN DOWN TO THE FUEL PUMP
There is a few online retailers with your part. see link for one example
A 1989 Pontiac Le Mans has a pair of sprockets. These sprockets are typically marked with alignment marks. One can use a wrench to align these marks, then use a pulley to set the belt on the sprockets.
You have to remove the timing belt cover,camshaft pulley and timing belt.Itis near the top behind the belt.
you need to post what engine it has then someone can ansewr it